A: |
This might be because you set the environment variables *after* already
compiling. The environment variables control C-pre-processor macros of
the same name and therefore influence what code gets compiled. It is
suggested to proceed with the following manual procedure to correct the
current installation:
Configure the environment according to the installation making sure
to -unset- the G4WORKDIR environment variable,
if set.
Verify and eventually set the environment variables of the
visualization module [name] concerned (setenv or export both
G4VIS_BUILD_[name]_DRIVER and
G4VIS_USE_[name] variables according to the UNIX
shell used), and then proceed as follows:
|