| tolerance |
| verbosity |
| resolution |
| recursion_start |
| recursion_depth |
| maximum_errors |
| check_parallel |
| run |
Define tolerance (in mm) by which overlaps reports
should be reported. By default, all overlaps are
reported, i.e. tolerance is set to: 0*mm.
Available at all Geant4 states.
Parameters
| Tolerance | type d | Omittable : current value is used as the default value. | |
| Unit | type s | Omittable : default value = mm | Parameter candidates : pc km m cm mm um nm Ang fm parsec kilometer meter centimeter millimeter micrometer nanometer angstrom fermi |
Specify if running in verbosity mode or not.
By default verbosity is set to ON (TRUE).
Available Geant4 state(s) : Idle
Parameters
| verbosity | type b | Omittable : default value = 1 |
Set the number of points on surface to be generated for
checking overlaps.
Available at all Geant4 states.
Parameters
| resolution | type i | Omittable : default value = 10000 |
Set the initial level in the geometry tree for recursion.
recursive_test will then start from the specified level.
Available at all Geant4 states.
Parameters
| initial_level | type i | Omittable : default value = 0 |
Set the depth in the geometry tree for recursion.
recursive_test will then stop after reached the specified depth.
By default, recursion will proceed for the whole depth.
Available at all Geant4 states.
Parameters
| recursion_depth | type i | Omittable : default value = -1 |
Set the maximum number of overlap errors to report
for each single volume being checked.
Once reached the maximum number specified, overlaps
affecting that volume further than that are simply ignored.
Available at all Geant4 states.
Parameters
| maximum_errors | type i | Omittable : default value = 1 |
Check for overlaps in parallel worlds.
By default, overlaps are only checked in the mass world (FALSE).
Available at all Geant4 states.
Parameters
| check_parallel | type b | Omittable : default value = 1 |
Start running the recursive overlap check.
Volumes are recursively asked to verify for overlaps
for points generated on the surface against their
respective mother volume and sisters at the same
level, performing for all daughters and daughters of
daughters, etc.
NOTE: it may take a very long time,
depending on the geometry complexity !
Available Geant4 state(s) : Idle