reset |
verbose |
check_mode |
push_notify |
Reset navigator and navigation history.
NOTE: must be called only after kernel has been
initialized once through the run manager!
Available Geant4 state(s) : Idle
Set run-time verbosity for the navigator.
0 : Silent (default)
1 : Display volume positioning and step lengths
2 : Display step/safety info on point location
3 : Display minimal state at -every- step
4 : Maximum verbosity (very detailed!)
NOTE: this command has effect -only- if Geant4 has
been installed with the G4VERBOSE flag set!
Range : level >=0 && level <=4
Available at all Geant4 states.
Parameters
level | type i | Omittable : default value = 0 |
Set navigator in -check_mode- state.
This will cause extra checks to be applied during
navigation. More strict and less tolerant conditions
are applied. A run-time performance penalty may be
observed when the -check_mode- state is activated.
NOTE: this command has effect -only- if Geant4 has
been installed with the G4VERBOSE flag set!
Available Geant4 state(s) : Idle
Parameters
checkFlag | type b | Omittable : default value = 0 |
Set navigator verbosity push notifications.
This allows one to disable/re-enable verbosity in
navigation, when tracks may get stuck and require
one artificial push along the direction by the
navigator. Notification is active by default.
NOTE: this command has effect -only- if Geant4 has
been installed with the G4VERBOSE flag set!
Available Geant4 state(s) : Idle
Parameters
pushFlag | type b | Omittable : default value = 1 |